Hi All,
I decided to write this little how-to after spending a lot of time trying to emulate my sentinel dongle. All the programs I used were not written by me and I am very grateful to all great guys here.
I emulated "Sentinel SuperPro"
1. Dump dongle with PVA 3.3 util with out "Brute WP" selected.
2. Solve the DMP file using "f1_nodongle" (10x to cEnginEEr) util, you should get XXXX.SSP file (~100kb).
3. Use "UniDumpToReg" util to convert the SSP to REG. Inside "UniDumpToReg" select your SSP file and then select "SafeKey ssp -> vUSB Sentinel" option and push "GO".
4. Open the REG file in Notepad or any other text editor and make the following changes:
"sntMemory"=hex:0A3E,1255,C5E3,0000,0009…..
To
"sntMemory"=hex:3E,0A,55,12,E3,C5,00,00,09,00… .. make this comma add and switch up to the end of this cell
5. Run "install.bat" from "vusbus" folder
6. Your comp should found new hardware and install it by it self
7. Import your changed REG in to the REGISTRY
8. Reboot